Bowers-group M&W Mechanical Depth Gauge 172 Series Instrukcja Użytkownika Pobierz pdf

DEPTH GAUGE INSTRUCTIONS

Mechanical Depth Gauge 172 Series

Please carefully review these instructions to ensure proper and accurate use of your new Depth Gauge.

For more information visit www.moore-and-wright.com Partners in Precision

Operation

Zero Point Confirmation

• Setting zero for measurements 0-25mm. Place the depth base on a surface plate or flat surface. Loosen the bezel lock screw, adjust the dial

on the depth gauge to the "0" position and tighten the screw.

Measuring Procedure

• For measuring lengths greater than 25mm add the necessary amount of measuring rods for the depth required.

• To ensure correct measurements after adding additional rods, the dial depth gauge should be set against a master part or a setting master

1: Tolerance markers

2: Bezel lock screw

3: Measuring base

4: Plunger

5: Extension rods 0-150mm

6: Spline point

7: Needle point

8: Ball point

Specification:

Indicator range: 0-25mm

Measuring range with extensions: 550mm

Graduations: 0.01mm

Zeroing the indicator

(without the extensions)

on a flat surface.

Installation of an

extension rod.

Zeroing the indicator

using an extension rod

and a setting master.

02_Manual_MW172-01 1/7/08 15:51 Page 1

DEPTH GAUGE INSTRUCTIONS 1

Podsumowanie treści

Strona 1 - DEPTH GAUGE INSTRUCTIONS

DEPTH GAUGE INSTRUCTIONSMechanical Depth Gauge 172 SeriesPlease carefully review these instructions to ensure proper and accurate use of your new Dept

Komentarze do niniejszej Instrukcji

Brak uwag

Bowers-group M&W Mechanical Depth Gauge 172 Series Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Urządzenia pomiarowe Bowers-group M&W Mechanical Depth Gauge 172 Series. Bowers Group M&W Mechanical Depth Gauge 172 Series User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Bowers-group M&W Mechanical Depth Gauge 172 Series